Spline always going up into the air?
|
Spline always going up into the air?
|
07-18-2020, 08:03 PM
I have to say it's still going up by the smallest amount, its barely noticeable but it's lifting slightly off the flat ground, I'm not using the conform path module in the generator (the path is flat anyway), is there any way to stop this happening? Would in fact using conform path force it down on to the flat terrain?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Spline always going up into the air? - by jamesunity - 07-17-2020, 10:22 PM
RE: Spline always going up into the air? - by _Aka_ - 07-17-2020, 11:27 PM
RE: Spline always going up into the air? - by jamesunity - 07-18-2020, 12:13 AM
RE: Spline always going up into the air? - by jamesunity - 07-18-2020, 08:03 PM
RE: Spline always going up into the air? - by _Aka_ - 07-19-2020, 01:18 PM
RE: Spline always going up into the air? - by jamesunity - 07-19-2020, 09:36 PM
RE: Spline always going up into the air? - by _Aka_ - 07-20-2020, 08:32 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Curvy Line Renderer for UI Spline? | gekido | 3 | 6 |
04-04-2024, 12:56 PM Last Post: _Aka_ |
|
| Get position of all control points for a spline | gekido | 1 | 6 |
03-28-2024, 10:08 PM Last Post: _Aka_ |
|
|
Changing spline connection in inspector causes splines to revert to defaults | lacota | 3 | 6 |
03-18-2024, 07:55 PM Last Post: _Aka_ |
| GO can't fit end of the spline | GameDeveloperek4123 | 3 | 14 |
03-04-2024, 11:06 AM Last Post: _Aka_ |
|
