12-26-2015, 09:15 PM
(This post was last modified: 12-26-2015, 10:16 PM by Trainzland.)
Hi,
I have connected 2 splines and a spline controller run on it. If the spline controller reach the connection it jumps to the first spline again and ignore the second one.
If I added the Curvy Default Event Handle as in Demo 03 then Unity totally crash if the SC reach the connection point.
I will post a bug report with example...
I have connected 2 splines and a spline controller run on it. If the spline controller reach the connection it jumps to the first spline again and ignore the second one.
If I added the Curvy Default Event Handle as in Demo 03 then Unity totally crash if the SC reach the connection point.
I will post a bug report with example...
(Henry Ford) Each hour more of searching is each hour less of your live time.