Curvy Splines Support Forum › Curvy Splines › Curvy Splines - support forum v
Is it possible to generate an output spline after the conform path module?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Is it possible to generate an output spline after the conform path module?
bennidhamma@gmail.com Offline
Junior Member
**
Posts: 4
Threads: 2
Joined: Mar 2021
#3
03-19-2021, 04:21 PM
Ahh, this sounds promising! I'll look into this. I'm using the train car manager, I'm guessing it shouldn't be too difficult to swap out the spline controller for the path controller, but I'll let check back in if I'm having trouble.

Thanks!
Find
Reply


Messages In This Thread
RE: Is it possible to generate an output spline after the conform path module? - by bennidhamma@gmail.com - 03-19-2021, 04:21 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Rasterized Path Range issue proton 7 23 04-30-2024, 11:17 AM
Last Post: _Aka_
  Incorrect mesh alignment after extrusion on curved path Thinkurvy 10 21 04-17-2024, 10:57 AM
Last Post: _Aka_
  Curvy Line Renderer for UI Spline? gekido 3 6 04-04-2024, 12:56 PM
Last Post: _Aka_
  Get position of all control points for a spline gekido 1 6 03-28-2024, 10:08 PM
Last Post: _Aka_

Forum Jump: