|
Spline Path Extrusion
|
12-26-2017, 06:02 AM
I realize that curvy extrudes meshes along the length of the path, but I want to create a cliff face with an overhang. So on each sides of the cliff I would have two paths, and want to know if Curvy can figure out mesh by morphing one path into the other. If not, I can write it myself, if there is some support of that, just seeing if that exists already and I'm not seeing it.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Spline Path Extrusion - by Elenesski - 12-26-2017, 01:25 AM
RE: Spline Path Extrusion - by Elenesski - 12-26-2017, 06:02 AM
RE: Spline Path Extrusion - by _Aka_ - 01-12-2018, 06:07 PM
RE: Spline Path Extrusion - by Elenesski - 01-17-2018, 02:45 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Rasterized Path Range issue | proton | 7 | 23 |
04-30-2024, 11:17 AM Last Post: _Aka_ |
|
| Incorrect mesh alignment after extrusion on curved path | Thinkurvy | 10 | 21 |
04-17-2024, 10:57 AM Last Post: _Aka_ |
|
| Curvy Line Renderer for UI Spline? | gekido | 3 | 6 |
04-04-2024, 12:56 PM Last Post: _Aka_ |
|
| Get position of all control points for a spline | gekido | 1 | 6 |
03-28-2024, 10:08 PM Last Post: _Aka_ |
|
