04-29-2014, 08:58 PM
It's hard to see in the Gizmo representation, but sometimes I think I see a "flat spot" sort of on either side of the control point. It feels really noticeable for example when there is a curve between two points and I want to add a point between those two, it immediately creates a dimple instead of adding a point along the existing spline between the two.
Using TCB, only thing checked is synchronize tcb on the control points themselves, no local values
Spline is set to TCB closed, granularity 40, orientation control point
Is there a way I could potentially send you stuff Jake without posting it here? I could probably make a video showing what is happening but not display that on the web.
Using TCB, only thing checked is synchronize tcb on the control points themselves, no local values
Spline is set to TCB closed, granularity 40, orientation control point
Is there a way I could potentially send you stuff Jake without posting it here? I could probably make a video showing what is happening but not display that on the web.
