04-01-2014, 08:17 PM
Ok, it's working now. Had to use Spline.OnRefresh, and in the callback had to check Spline.IsInitialized and mSpline.Length != 0.
Curvy Splines Support Forum
›
Curvy Splines
›
Curvy Splines - support forum
Changing control points at runtime
Changing control points at runtime
|
Changing control points at runtime
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Changing control points at runtime - by uli - 04-01-2014, 02:33 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Set Volume to the Volume Controller at Runtime | pako88 | 2 | 10 |
04-08-2024, 03:26 PM Last Post: _Aka_ |
|
| snap to the curve created by the curvy splines segment points | ShiroeYamamoto | 3 | 11 |
04-02-2024, 02:24 PM Last Post: _Aka_ |
|
| Get position of all control points for a spline | gekido | 1 | 6 |
03-28-2024, 10:08 PM Last Post: _Aka_ |
|
|
Changing spline connection in inspector causes splines to revert to defaults | lacota | 3 | 6 |
03-18-2024, 07:55 PM Last Post: _Aka_ |