05-14-2025, 11:54 AM
Hi again,
Disabling segments of a spline is not supported. A spline has either to be fully enabled or fully disabled. If you want to switch between two versions of a spline, duplicate the spline, remove the segments in the second spline, and then switch the spline controller between the two splines.
Did this help?
Have a nice day.
Disabling segments of a spline is not supported. A spline has either to be fully enabled or fully disabled. If you want to switch between two versions of a spline, duplicate the spline, remove the segments in the second spline, and then switch the spline controller between the two splines.
Did this help?
Have a nice day.
Please consider leaving a review for Curvy Splines, this helps immensely. Thank you.
