09-21-2016, 08:45 PM
Just a small piece of feedback, it wasn't immediately obvious how I should set up a connection between two points, and the UI for the FollowUp/Head To documentation leaves a little to be desired in understanding how it all works.
I understand that if I sync position/rotation between the connections, it will ensure all connections share such data.
What I don't understand is what the FollowUp node does -- can you try to explain a few use cases why I'd want the FollowUp node to point the start or end of a spline? Could you describe what happens when the option is set to auto, or not set at all?
Finally, what's the benefit of not specifying a followup node for a connection?
(Thanks! Pretty impressed with everything so far.)
I understand that if I sync position/rotation between the connections, it will ensure all connections share such data.
What I don't understand is what the FollowUp node does -- can you try to explain a few use cases why I'd want the FollowUp node to point the start or end of a spline? Could you describe what happens when the option is set to auto, or not set at all?
Finally, what's the benefit of not specifying a followup node for a connection?
(Thanks! Pretty impressed with everything so far.)
