Hello,
I'd like to connect last and first CP (only them) so I can generate mesh at this section. If I set splines last CP (41st) as the Start CP, I cannot set CP0000 ast the End CP. Leaving End CP empty basicaly creates mesh between CP0000 and CP0041 without connecting last and first even though I have set Connected to true in the spline itself.
![[Image: AKrjxCX.png]](https://i.imgur.com/AKrjxCX.png)
I'd like to connect last and first CP (only them) so I can generate mesh at this section. If I set splines last CP (41st) as the Start CP, I cannot set CP0000 ast the End CP. Leaving End CP empty basicaly creates mesh between CP0000 and CP0041 without connecting last and first even though I have set Connected to true in the spline itself.