11-15-2015, 09:26 PM
This should work. Note that setting Position (or RelativePosition) works only if the controller is running! If not running, use InitialPosition!
Curvy Splines Support Forum
›
Curvy Splines
›
Curvy Splines - support forum
set SplineController position from code
set SplineController position from code
|
set SplineController position from code
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
set SplineController position from code - by edwon - 11-15-2015, 07:50 PM
RE: set SplineController position from code - by Jake - 11-15-2015, 09:26 PM
RE: set SplineController position from code - by edwon - 11-15-2015, 10:03 PM
RE: set SplineController position from code - by Jake - 11-16-2015, 07:05 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Get position of all control points for a spline | gekido | 1 | 6 |
03-28-2024, 10:08 PM Last Post: _Aka_ |
|
| Avoiding runtime GC allocations on control point position change | Ell223 | 8 | 18 |
02-24-2024, 10:43 AM Last Post: _Aka_ |
|
| How could I get position in spline from "From" value in BuildRasterizedPath? | Chanon | 1 | 8 |
02-12-2024, 09:54 PM Last Post: _Aka_ |
|
| Finding relative position across connected splines | DekoGames | 1 | 8 |
02-05-2024, 10:11 PM Last Post: _Aka_ |
|