11-11-2022, 10:00 PM
Using a Variable Shape Mixer Or the X Multiplier under Scale of the Shape Extrusion module to control the width of my track profile I'm still left with a problem. I still need to create a guardrail.
In the 25_CGExtrusionAdvanced you make a Shape Extrusion 'wire'. This wire follows the spline, just vertically offset by a fixed amount using a TRS Mesh module.
But a guardrail needs to follow the extruded cross-section's width. This width varies based upon the Shape Extrusion via one of the two methods described above.
I'm still unsure how to do this?
I'm sorry if I missed your explanation previously. I should have separated all these issues as they came up.
In the 25_CGExtrusionAdvanced you make a Shape Extrusion 'wire'. This wire follows the spline, just vertically offset by a fixed amount using a TRS Mesh module.
But a guardrail needs to follow the extruded cross-section's width. This width varies based upon the Shape Extrusion via one of the two methods described above.
I'm still unsure how to do this?
I'm sorry if I missed your explanation previously. I should have separated all these issues as they came up.