10-29-2021, 12:18 PM
(10-29-2021, 06:53 AM)Zendariel Wrote: The range variable was not applicable because the Spline could not be clamped for the end/beginning of the loop, so it did not work the same way as it would on an open spline.If I am not misunderstanding, you could have two Shape Extrusion modules both with ranges, one from say 0.8 to 1, the other from say 0 to 0.3.
Even though your modified module fits properly your needs, without having to have two Shape Extrusion modules, please let me know if what I suggested is an alternative solution to your issue.
Thanks a lot, and have a nice day
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.