10-29-2021, 06:53 AM
(10-28-2021, 04:51 PM)_Aka_ Wrote: Hi
What about using the Range parameter in the Shape Extrusion module? Does it fit your needs?
https://curvyeditor.com/documentation/generator/modules/shapeextrusion#range
No, but I was able to achieve the targeted result by changing the source code for the input spline module to accept a lower end point and changing the calculations to take that case into account. So I'm now able to create a Mesh for example from point 15 to 4.
The range variable was not applicable because the Spline could not be clamped for the end/beginning of the loop, so it did not work the same way as it would on an open spline.
Thanks for the response.