02-15-2020, 09:03 AM
Hi. I just wondered if there was a built in way if doing that.
As what i want to achieve will be at runtime what i could do is store the info of each control point then redraw the spline but adding the new connection control point at the appropriate place, ie if between cp 1 and 2 the new control point would become cp0002 then all subsequent control points would be one number higher it'd that makes sense.
As what i want to achieve will be at runtime what i could do is store the info of each control point then redraw the spline but adding the new connection control point at the appropriate place, ie if between cp 1 and 2 the new control point would become cp0002 then all subsequent control points would be one number higher it'd that makes sense.