I made this road:
https://gyazo.com/fda1bca0d673d4757c36a8353af36c7a
I have 2 questions:
1) Is it possible to use one Input Spline Path and instead of using Path > Range of Shape Extrusion module for specifying range ? I mean using Control Points instead of Range.
2) I use this Input Spline Shape for generating 2 lanes and for 4 lanes this one . My problem is I should change UV scale and offset to make them same when they are connected to each other. Is it normal or I can do something to perform this job automatically ?
With offsetting and scaling | Without offsetting and scaling
https://gyazo.com/fda1bca0d673d4757c36a8353af36c7a
I have 2 questions:
1) Is it possible to use one Input Spline Path and instead of using Path > Range of Shape Extrusion module for specifying range ? I mean using Control Points instead of Range.
2) I use this Input Spline Shape for generating 2 lanes and for 4 lanes this one . My problem is I should change UV scale and offset to make them same when they are connected to each other. Is it normal or I can do something to perform this job automatically ?
With offsetting and scaling | Without offsetting and scaling