06-26-2019, 09:14 AM
Hi again,
I have extruded my mesh successfully, but as I try to give it a material, it gets all stretched out.
I have tried to change the UV scale in the Volume Mesh module, but it doesn't seem to fix the issue. My material is displayed normal on a 1*1*1 cube. If I apply another material to the mesh, the result is similar.
How can I fix this?
https://imgur.com/HlWnp9X
https://imgur.com/5zoHzcJ
I have extruded my mesh successfully, but as I try to give it a material, it gets all stretched out.
I have tried to change the UV scale in the Volume Mesh module, but it doesn't seem to fix the issue. My material is displayed normal on a 1*1*1 cube. If I apply another material to the mesh, the result is similar.
How can I fix this?
https://imgur.com/HlWnp9X
https://imgur.com/5zoHzcJ