03-08-2016, 07:39 AM
Limiting the range in the SplinePath module is the right way. Could you ensure that the range's EndCP is higher than the StartCP. Fields shouldn't get cleared then.
Curvy Splines Support Forum
›
Curvy Splines
›
Curvy Splines - support forum
Input Spline Path have a CP Range to or across Segment 0
Input Spline Path have a CP Range to or across Segment 0
|
Input Spline Path have a CP Range to or across Segment 0
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Input Spline Path have a CP Range to or across Segment 0 - by nictringali - 03-08-2016, 01:58 AM
RE: Input Spline Path have a CP Range to or across Segment 0 - by Jake - 03-08-2016, 07:39 AM
RE: Input Spline Path have a CP Range to or across Segment 0 - by nictringali - 03-08-2016, 11:51 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Rasterized Path Range issue | proton | 7 | 23 |
04-30-2024, 11:17 AM Last Post: _Aka_ |
|
| Incorrect mesh alignment after extrusion on curved path | Thinkurvy | 10 | 21 |
04-17-2024, 10:57 AM Last Post: _Aka_ |
|
| Curvy Line Renderer for UI Spline? | gekido | 3 | 6 |
04-04-2024, 12:56 PM Last Post: _Aka_ |
|
| snap to the curve created by the curvy splines segment points | ShiroeYamamoto | 3 | 11 |
04-02-2024, 02:24 PM Last Post: _Aka_ |
|