11-19-2015, 05:46 PM
CG currently only works on spline level. But with connections you can ensure that two splines connect perfectly, thus making generated meshes line up properly.
Curvy Splines Support Forum
›
Curvy Splines
›
Curvy Splines - support forum
Merge and Split path with Generator
Merge and Split path with Generator
|
Merge and Split path with Generator
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Merge and Split path with Generator - by PassivePicasso - 11-18-2015, 04:19 PM
RE: Merge and Split path with Generator - by Jake - 11-19-2015, 05:46 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Incorrect mesh alignment after extrusion on curved path | Thinkurvy | 10 | 21 |
04-17-2024, 10:57 AM Last Post: _Aka_ |
|
| Rasterized Path Range issue | proton | 2 | 12 |
04-15-2024, 03:42 PM Last Post: _Aka_ |
|
| 8.8.0 is live, and it improves Curvy Generator greatly | _Aka_ | 1 | 10 |
04-03-2024, 03:16 PM Last Post: _Aka_ |
|
|
Extending Curvy Generator for Advanced Lofting - Feasibility Check | amutp | 2 | 5 |
03-27-2024, 07:25 AM Last Post: amutp |