Hello,
I have two issues:
1) My mesh generator uses two Splines as profiles to be able to change the width of each spline segment from one control point to the next. Currently, the leading profile is seems to have a problem with the mesh that is generated. I have tried to figure out what the problem is without success. Can you tell me what setting is causing this cut corner on the mesh?
The attached MeshIncorrect shows the issue. The entire project is attached in the zip file UVTest.zip
2) I use KeepAspect.ScaleV to make the texture look good on the surface. But since each of the spline segments have their own generated meshes, I'd like to use UVOffset.Y to adjust the follow on texture so it starts where the previous segments texture ended. The problem is I don't know how to compute the proper value for this given the length of the segment and/or texture size and/or ??? Suggestions?
Picture of what I am trying to do are attached. AlignVs1.jpg shows how the texture don't align at the control point. With AlignVs2.jpg I manually adjust the UVOffset.Y on the follow on segment to show how it should look continuous. How can I calculate this automatically?
I have two issues:
1) My mesh generator uses two Splines as profiles to be able to change the width of each spline segment from one control point to the next. Currently, the leading profile is seems to have a problem with the mesh that is generated. I have tried to figure out what the problem is without success. Can you tell me what setting is causing this cut corner on the mesh?
The attached MeshIncorrect shows the issue. The entire project is attached in the zip file UVTest.zip
2) I use KeepAspect.ScaleV to make the texture look good on the surface. But since each of the spline segments have their own generated meshes, I'd like to use UVOffset.Y to adjust the follow on texture so it starts where the previous segments texture ended. The problem is I don't know how to compute the proper value for this given the length of the segment and/or texture size and/or ??? Suggestions?
Picture of what I am trying to do are attached. AlignVs1.jpg shows how the texture don't align at the control point. With AlignVs2.jpg I manually adjust the UVOffset.Y on the follow on segment to show how it should look continuous. How can I calculate this automatically?
