Curvy Splines Support Forum › Curvy Splines › Curvy Splines - support forum v
Adding OnSwitch event via Script

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding OnSwitch event via Script
_Aka_ Offline
Administrator
*******
Posts: 1,976
Threads: 82
Joined: Jun 2017
#4
01-09-2021, 05:25 PM
Sorry, that's not when that event is raised. Here is the corrected documentation that hopefully will avoid confusion.
"Event raised while switching splines. Splines switching is done via the SwitchTo method."
If you want to know if a controller reached a connection, use the OnCPReached, and check in it if the reached CP has a Connection (controlPoint.Connection)
Did this help?
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Find
Reply


Messages In This Thread
Adding OnSwitch event via Script - by NovoNG - 01-09-2021, 12:00 PM
RE: Adding OnSwitch event via Script - by _Aka_ - 01-09-2021, 12:58 PM
RE: Adding OnSwitch event via Script - by NovoNG - 01-09-2021, 03:02 PM
RE: Adding OnSwitch event via Script - by _Aka_ - 01-09-2021, 05:25 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Adjust radius of generated mesh via script? Shackman 1 4 03-26-2024, 01:12 PM
Last Post: _Aka_
  Adding Begining and End Mesh to Spline velikizlivuk 2 4 08-02-2023, 11:10 AM
Last Post: velikizlivuk
  Way to get objects script from generator Lupos 10 29 05-26-2023, 09:51 AM
Last Post: _Aka_
  Adding a CP breaks the mesh lethekun 3 6 05-25-2022, 01:53 AM
Last Post: _Aka_

Forum Jump: