01-30-2017, 06:01 PM
Hi Pete,
Q1: That shouldn't happen and I never came across such an issue, so I guess it must be a wrong setting. Try using only SpaceBefore or SpaceAfter. Also, check rasterization (easiest is to add a debug module and visualize the points). Perhaps the spline results into too less rasterization points (or is very small?). If you see nothing strange, consider sending me a repo scene by mail.
Q2: If you mean thickness of the extrusion, then you can alter the scale in the Extrusion module.
Q3: No news yet, sorry. But working conditions will get far better this spring - we're moving and I'll get my dedicated office back...
Q1: That shouldn't happen and I never came across such an issue, so I guess it must be a wrong setting. Try using only SpaceBefore or SpaceAfter. Also, check rasterization (easiest is to add a debug module and visualize the points). Perhaps the spline results into too less rasterization points (or is very small?). If you see nothing strange, consider sending me a repo scene by mail.
Q2: If you mean thickness of the extrusion, then you can alter the scale in the Extrusion module.
Q3: No news yet, sorry. But working conditions will get far better this spring - we're moving and I'll get my dedicated office back...
