12-15-2022, 08:30 AM
Instead of generating a hard edge / cap, I am looking into ways to generate a beveled/rounded edge for the volume caps. Is this possible?
How to generate bevels at volume caps
|
12-15-2022, 08:30 AM
Instead of generating a hard edge / cap, I am looking into ways to generate a beveled/rounded edge for the volume caps. Is this possible?
12-16-2022, 10:55 AM
Sorry, not possible for now. A workaround would be to create separately that mesh and then place it at the start/end of your extrusion.
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
12-16-2022, 06:02 PM
12-17-2022, 10:20 AM
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
|
« Next Oldest | Next Newest »
|
Possibly Related Threads… | |||||
Thread | Author | Replies | Views | Last Post | |
Set Volume to the Volume Controller at Runtime | pako88 | 2 | 10 |
04-08-2024, 03:26 PM Last Post: _Aka_ |
|
Volume Spots inter group distance | Sacryn | 1 | 3 |
02-27-2024, 04:08 PM Last Post: _Aka_ |
|
Cant Generate Meshes At Runtime | alms94 | 5 | 22 |
01-26-2024, 11:27 AM Last Post: _Aka_ |
|
Newbie Question: Uniformly increase spacing between volume spots? | SAMYTHEBIGJUICY | 1 | 5 |
09-01-2023, 03:38 PM Last Post: _Aka_ |