Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Sync orientation at connection points (Dynamic))
#1
As the tiles says, I want to sync orientation at connection points when spline orientation is set to Dynamic.

https://gyazo.com/c3ae8471b6419aa8403b67438cc5bc1d
Reply
#2
I think setting that CP as an orientation anchor would fix the issue. If not, please send me a reproduction case
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Disable rebuild of meshes in dynamic mode Zilk1 2 9 05-24-2024, 10:52 AM
Last Post: Zilk1
  snap to the curve created by the curvy splines segment points ShiroeYamamoto 3 11 04-02-2024, 02:24 PM
Last Post: _Aka_
  Get position of all control points for a spline gekido 1 6 03-28-2024, 10:08 PM
Last Post: _Aka_
Bug Changing spline connection in inspector causes splines to revert to defaults lacota 3 6 03-18-2024, 07:55 PM
Last Post: _Aka_

Forum Jump: