Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Connection noob, all round noob in fairness
#1
Hi, was hoping someone could help me out? So I am trying to connect 2 splines together, one horizontal one vertical. I have a flying creature attached with a spline controller, and when I reach the end of the horizontal spline I need it to immediately drop vertically. I am pressing connect on the end and start cp's, but the drop down doesn't see either. I am new to this and would greatly appreciate some help out of this hole Smile  Alan.
Reply
#2
Hi,
You will need to define the controller's behavior when reaching a connection. See the doc here https://curvyeditor.com/documentation/controllers#connections_handling
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
Bug Changing spline connection in inspector causes splines to revert to defaults lacota 3 6 03-18-2024, 07:55 PM
Last Post: _Aka_
Thumbs Up Can't delete connection lacota 3 6 03-16-2024, 11:34 AM
Last Post: _Aka_
Lightbulb Junction & Connection Navigation System Design SAMYTHEBIGJUICY 4 13 11-27-2023, 01:04 PM
Last Post: _Aka_
  Connection "next' control point jh092 3 15 11-22-2023, 11:47 AM
Last Post: _Aka_

Forum Jump: