Curvy Splines Support Forum › Curvy Splines › Curvy Splines - support forum v
Allow higher amount of mesh-faces on extrusion

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Allow higher amount of mesh-faces on extrusion
King_of_Limbs Offline
Junior Member
**
Posts: 2
Threads: 1
Joined: Jul 2020
#3
07-11-2020, 04:25 PM
I had Cache Density at 100 which does not work as I would think it should?:
[Image: p.png?fv_content=true&size_mode=5]

It only starts having an effect when i massively turn up the Max Points per Unit. Then I get like 8 mesh faces:
[Image: p.png?fv_content=true&size_mode=5]
Find
Reply


Messages In This Thread
RE: Allow higher amount of mesh-faces on extrusion - by King_of_Limbs - 07-11-2020, 04:25 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Incorrect mesh alignment after extrusion on curved path Thinkurvy 10 21 04-17-2024, 10:57 AM
Last Post: _Aka_
  Adjust radius of generated mesh via script? Shackman 1 4 03-26-2024, 01:12 PM
Last Post: _Aka_
  Not seeing mesh extended after following YT PaulM 1 3 02-02-2024, 12:01 PM
Last Post: _Aka_
  Trigger Zones along Spline Mesh dlees9191 1 5 01-05-2024, 10:18 AM
Last Post: _Aka_

Forum Jump: