Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Allow higher amount of mesh-faces on extrusion
#2
Hi,
The problem is not there, but in the cache density of your spline. For very small splines, the default cache density is not high enough. Read this to see how to fix that:
https://curvyeditor.com/documentation/performancetips#set_the_correct_number_of_cache_points
Have a nice day
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Reply


Messages In This Thread
RE: Allow higher amount of mesh-faces on extrusion - by _Aka_ - 07-11-2020, 03:14 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Incorrect mesh alignment after extrusion on curved path Thinkurvy 10 21 04-17-2024, 10:57 AM
Last Post: _Aka_
  Adjust radius of generated mesh via script? Shackman 1 4 03-26-2024, 01:12 PM
Last Post: _Aka_
  Not seeing mesh extended after following YT PaulM 1 3 02-02-2024, 12:01 PM
Last Post: _Aka_
  Trigger Zones along Spline Mesh dlees9191 1 5 01-05-2024, 10:18 AM
Last Post: _Aka_

Forum Jump: