05-26-2020, 11:30 AM
Hi,
There is indeed a difference. Controllers use the TF, and extrusion uses relative distance (distance / spline's length).
A solution, besides doing the conversion yourself, is to use a Path Controller instead of a Spline Controller, because it uses relative distances.
Did this help?
There is indeed a difference. Controllers use the TF, and extrusion uses relative distance (distance / spline's length).
A solution, besides doing the conversion yourself, is to use a Path Controller instead of a Spline Controller, because it uses relative distances.
Did this help?
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.