02-09-2020, 06:22 AM
Hey there,
I have noticed the problem which happens to the mesh in generator.
When I try to rotate control points for rotating spline something weird happens. Check out this gif:
https://gyazo.com/a84f1b302cade804ea913cc2fb5a5d36
As you can see when I'm trying to rotate one of control points, the road rotate in a weird approach.
After a little bit searching in the editor, I just noticed it is because of optimize checkbox in Shape Extrusion, Path tab. If it is disabled, there is no problem but when it is active this weird thing happens.
Could you tell me what optimize do and why there is this problem ?
I have noticed the problem which happens to the mesh in generator.
When I try to rotate control points for rotating spline something weird happens. Check out this gif:
https://gyazo.com/a84f1b302cade804ea913cc2fb5a5d36
As you can see when I'm trying to rotate one of control points, the road rotate in a weird approach.
After a little bit searching in the editor, I just noticed it is because of optimize checkbox in Shape Extrusion, Path tab. If it is disabled, there is no problem but when it is active this weird thing happens.
Could you tell me what optimize do and why there is this problem ?