Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Infinite loop in FixedDistance mesh generation
#2
I just wanted to say I think I've been running into this problem, but I wasn't able to nail down the cause.

Thank you for shedding some light on this, I'm going to be doing some testing tonight to see if I can work around the bug until an official solution.

If I find anything to add I'll make sure to note it here
Reply


Messages In This Thread

Possibly Related Threads…
Thread Author Replies Views Last Post
  Incorrect mesh alignment after extrusion on curved path Thinkurvy 10 21 04-17-2024, 10:57 AM
Last Post: _Aka_
  Adjust radius of generated mesh via script? Shackman 1 4 03-26-2024, 01:12 PM
Last Post: _Aka_
  Not seeing mesh extended after following YT PaulM 1 3 02-02-2024, 12:01 PM
Last Post: _Aka_
  Trigger Zones along Spline Mesh dlees9191 1 5 01-05-2024, 10:18 AM
Last Post: _Aka_

Forum Jump: