06-25-2019, 12:17 AM
Hi,
Based on your scene, if you set the angle threshold to 0.1 in the Shape Extrusion module, and set the Max Points Per Unit to 50 in the spline named Input Spline Path_2_Spline, you will get the following result:
Much better, but still not a right angle.
If this result is not good enough, let me know and I will try to figure out a solution for your use case
Based on your scene, if you set the angle threshold to 0.1 in the Shape Extrusion module, and set the Max Points Per Unit to 50 in the spline named Input Spline Path_2_Spline, you will get the following result:
Much better, but still not a right angle.
If this result is not good enough, let me know and I will try to figure out a solution for your use case
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
