06-20-2019, 05:54 PM
Hi,
Your issue comes from the the fact that your extrusion's cross is the same spline as your extrusion's path.
https://curvyeditor.com/documentation/generator/modules/shapeextrusion#input
By setting a rectangle for example as your extrusion's cross, your will have a coherent result. Then just follow the warnings displayed in the modules.
PS: If the spots limitations is too low for you, search for this code in BuildVolumeSpot.cs, and set whatever value you want:
const int MaxSpotsCount = 10000;
Your issue comes from the the fact that your extrusion's cross is the same spline as your extrusion's path.
https://curvyeditor.com/documentation/generator/modules/shapeextrusion#input
By setting a rectangle for example as your extrusion's cross, your will have a coherent result. Then just follow the warnings displayed in the modules.
PS: If the spots limitations is too low for you, search for this code in BuildVolumeSpot.cs, and set whatever value you want:
const int MaxSpotsCount = 10000;
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.