01-12-2018, 08:22 AM
I fixed this by switching off combine
Mesh.normals is out of bounds
|
« Next Oldest | Next Newest »
|
Messages In This Thread |
Mesh.normals is out of bounds - by hawken - 01-12-2018, 07:21 AM
RE: Mesh.normals is out of bounds - by hawken - 01-12-2018, 08:22 AM
RE: Mesh.normals is out of bounds - by _Aka_ - 01-12-2018, 04:15 PM
RE: Mesh.normals is out of bounds - by _Aka_ - 01-12-2018, 07:23 PM
RE: Mesh.normals is out of bounds - by hawken - 01-15-2018, 03:13 AM
RE: Mesh.normals is out of bounds - by _Aka_ - 01-15-2018, 03:22 PM
RE: Mesh.normals is out of bounds - by _Aka_ - 01-16-2018, 08:43 PM
|
Possibly Related Threads… | |||||
Thread | Author | Replies | Views | Last Post | |
Incorrect mesh alignment after extrusion on curved path | Thinkurvy | 10 | 21 |
04-17-2024, 10:57 AM Last Post: _Aka_ |
|
Adjust radius of generated mesh via script? | Shackman | 1 | 4 |
03-26-2024, 01:12 PM Last Post: _Aka_ |
|
Not seeing mesh extended after following YT | PaulM | 1 | 3 |
02-02-2024, 12:01 PM Last Post: _Aka_ |
|
Trigger Zones along Spline Mesh | dlees9191 | 1 | 5 |
01-05-2024, 10:18 AM Last Post: _Aka_ |