09-18-2016, 03:29 AM
How do I force the creation of a mesh at runtime? If I use a generator, the mesh gets created if I run the creation through a co-routine, but how do I force the mesh to be created without a co-routine?
Force Mesh creation at runtime?
|
« Next Oldest | Next Newest »
|
Messages In This Thread |
Force Mesh creation at runtime? - by Elenesski - 09-18-2016, 03:29 AM
RE: Force Mesh creation at runtime? - by Jake - 09-19-2016, 03:15 PM
RE: Force Mesh creation at runtime? - by Elenesski - 09-19-2016, 07:56 PM
RE: Force Mesh creation at runtime? - by Jake - 09-21-2016, 06:56 PM
RE: Force Mesh creation at runtime? - by Elenesski - 09-21-2016, 07:15 PM
|
Possibly Related Threads… | |||||
Thread | Author | Replies | Views | Last Post | |
Incorrect mesh alignment after extrusion on curved path | Thinkurvy | 10 | 21 |
04-17-2024, 10:57 AM Last Post: _Aka_ |
|
Set Volume to the Volume Controller at Runtime | pako88 | 2 | 10 |
04-08-2024, 03:26 PM Last Post: _Aka_ |
|
Adjust radius of generated mesh via script? | Shackman | 1 | 4 |
03-26-2024, 01:12 PM Last Post: _Aka_ |
|
Avoiding runtime GC allocations on control point position change | Ell223 | 8 | 18 |
02-24-2024, 10:43 AM Last Post: _Aka_ |