Hi. An enabled spline needs that its control points be enabled too. Disabling the CPs should not throw those null reference errors though. I will investigate this:
1- Can you tell me what version of Curvy Splines do you use?
2- What were the reproduction steps?
Also, can you please tell me in what use case you want to disable the control points without disabling the whole done?
1- Can you tell me what version of Curvy Splines do you use?
2- What were the reproduction steps?
Also, can you please tell me in what use case you want to disable the control points without disabling the whole done?
Available for freelance work, feel free to reach out: toolbuddy.net
Please consider leaving a review for Curvy, this helps immensely. Thank you.
Please consider leaving a review for Curvy, this helps immensely. Thank you.