06-08-2014, 02:26 PM
Hi,
I'm aligning objects on the spline and having characters run on it which all works fine, but i'm also using the mesh builder to extrude the basic rectangle shape along the spline to make for a road. The problem is that the builder doesn't seem to support extruding the shape negatively along the up vectors, forcing me to give all the things i place on the spline a vertical offsets and making things a bit difficult especially if the extrusion is quite high.
I tried getting around this by using custom shapes, but i get the same bug as discussed in the thread below and the mesh ends up being broken. It doesn't seem a large change to me to allow negative extrusion , so is it possible we might see this in a future release?
Thanks!
I'm aligning objects on the spline and having characters run on it which all works fine, but i'm also using the mesh builder to extrude the basic rectangle shape along the spline to make for a road. The problem is that the builder doesn't seem to support extruding the shape negatively along the up vectors, forcing me to give all the things i place on the spline a vertical offsets and making things a bit difficult especially if the extrusion is quite high.
I tried getting around this by using custom shapes, but i get the same bug as discussed in the thread below and the mesh ends up being broken. It doesn't seem a large change to me to allow negative extrusion , so is it possible we might see this in a future release?
Thanks!