Can generated mesh be enabled to read/write?
|
Can generated mesh be enabled to read/write?
|
04-07-2022, 01:13 PM
(04-07-2022, 01:02 PM)_Aka_ Wrote: Can you check on your side that the meshes generated by Curvy have isReadable set to true? Or simply check the Read/Write Enabled in the mesh's inspector, that's way easier 
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Can generated mesh be enabled to read/write? - by scr33ner - 04-06-2022, 05:15 PM
RE: Can generated mesh be enabled to read/write? - by _Aka_ - 04-07-2022, 01:02 PM
RE: Can generated mesh be enabled to read/write? - by _Aka_ - 04-07-2022, 01:13 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Incorrect mesh alignment after extrusion on curved path | Thinkurvy | 10 | 21 |
04-17-2024, 10:57 AM Last Post: _Aka_ |
|
| Adjust radius of generated mesh via script? | Shackman | 1 | 4 |
03-26-2024, 01:12 PM Last Post: _Aka_ |
|
| Not seeing mesh extended after following YT | PaulM | 1 | 3 |
02-02-2024, 12:01 PM Last Post: _Aka_ |
|
| Trigger Zones along Spline Mesh | dlees9191 | 1 | 5 |
01-05-2024, 10:18 AM Last Post: _Aka_ |
|
