Mesh Generation between two splines
|
Mesh Generation between two splines
|
02-03-2025, 10:55 AM
Hi,
You can't, but you can merge the 2 different splines into one (by moving the control points of a spline into the other), and then use that spline to generate a mesh. Did this help?
Please consider leaving a review for Curvy Splines, this helps immensely. Thank you.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Mesh Generation between two splines - by vatan - 02-03-2025, 07:27 AM
RE: Mesh Generation between two splines - by _Aka_ - 02-03-2025, 10:55 AM
RE: Mesh Generation between two splines - by vatan - 02-03-2025, 12:51 PM
RE: Mesh Generation between two splines - by _Aka_ - 02-03-2025, 02:17 PM
RE: Mesh Generation between two splines - by vatan - 02-14-2025, 07:11 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Is there a way to generate UVs along deformed and copied mesh? | kubak | 1 | 627 |
03-18-2026, 08:34 PM Last Post: _Aka_ |
|
| Connections Between Opposing Splines | lockiidraws | 1 | 861 |
12-04-2025, 02:14 PM Last Post: _Aka_ |
|
| Replace deform mesh on volume spots | Kokoriko49 | 1 | 2,573 |
06-09-2025, 06:49 PM Last Post: _Aka_ |
|
| Spawn at start/ end of splines | rickgplus | 4 | 3,325 |
03-21-2025, 12:34 PM Last Post: _Aka_ |
|
