Toolbuddy Support Forum › Unity Asset Support Forums › Curvy Splines v
Is it possible to make the face at the end of mesh?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Is it possible to make the face at the end of mesh?
Chanon Offline
Junior Member
**
Posts: 21
Threads: 13
Joined: Jun 2022
#1
11-13-2024, 07:27 AM
I create pipe mesh by Shape Extrusion but the head and the end of the mesh has no face. 
Is it possible to make the face at the head and the end of the pipe mesh by curvy spline?
Find
Reply


Messages In This Thread
Is it possible to make the face at the end of mesh? - by Chanon - 11-13-2024, 07:27 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Is there a way to generate UVs along deformed and copied mesh? kubak 1 317 03-18-2026, 08:34 PM
Last Post: _Aka_
  Replace deform mesh on volume spots Kokoriko49 1 2,325 06-09-2025, 06:49 PM
Last Post: _Aka_
  Mesh Generation between two splines vatan 4 3,634 02-14-2025, 07:11 AM
Last Post: vatan
  Create Mesh Node, Make Static Options rickgplus 1 1,833 01-23-2025, 10:12 AM
Last Post: _Aka_

Forum Jump: