03-27-2023, 07:10 AM
Hi, I would have used the in-engine bug report as requested in the forum post but it's not obvious to me where that option is, so i'm posting here instead.
I have a fairly simple set up of a single 3 point spline sweep, tapering at the end. The goal is to use this as a mouse directional indicator from a digital card source for deployment, etc.
However when I move the control points in a script, my console is spammed with the following:
"[Curvy] Deadloop in CurvySpline.Refresh! Please raise a bugreport!"
using I believe curvy 8.
Happy to provide any further information necessary if instructions are given on how to provide it.
nullnull
I have a fairly simple set up of a single 3 point spline sweep, tapering at the end. The goal is to use this as a mouse directional indicator from a digital card source for deployment, etc.
However when I move the control points in a script, my console is spammed with the following:
"[Curvy] Deadloop in CurvySpline.Refresh! Please raise a bugreport!"
using I believe curvy 8.
Happy to provide any further information necessary if instructions are given on how to provide it.
nullnull