Toolbuddy Support Forum › Unity Asset Support Forums › Curvy Splines v
Connection extrusion

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Connection extrusion
briceio Offline
Junior Member
**
Posts: 3
Threads: 2
Joined: Jun 2020
#1
08-04-2022, 12:24 PM (This post was last modified: 08-04-2022, 12:29 PM by briceio.)
Hello there,

Before I start writing my own code for this case… I'd like to know if there is something to handle this situation (I tried all the tools in the Curvy Generator but couldn't find anything =P): the extrusion of two paths linked with a common connection.

[Image: Curvy1.png]

[Image: Curvy2.png]

[Image: Curvy3.png]

Thanks for any pointer or feedback!

Keep up this great extension Smile
Find
Reply


Messages In This Thread
Connection extrusion - by briceio - 08-04-2022, 12:24 PM
RE: Connection extrusion - by _Aka_ - 08-04-2022, 12:36 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
Lightbulb Junction & Connection Navigation System Design SAMYTHEBIGJUICY 6 3,474 03-25-2026, 10:10 PM
Last Post: _Aka_
  Anomalous connection handling SAMYTHEBIGJUICY 1 1,362 12-04-2024, 05:08 PM
Last Post: _Aka_
  Incorrect mesh alignment after extrusion on curved path Thinkurvy 10 5,120 04-17-2024, 10:57 AM
Last Post: _Aka_
Bug Changing spline connection in inspector causes splines to revert to defaults lacota 3 2,645 03-18-2024, 07:55 PM
Last Post: _Aka_

Forum Jump: