05-02-2021, 09:39 AM
In the generator settings is there a way to disable generation until a set number of points have been added to the spline?
Toolbuddy Support Forum
›
Unity Asset Support Forums
›
Curvy Splines
Disabled mesh generation until a certain number of CPs are added.
Disabled mesh generation until a certain number of CPs are added.
|
Disabled mesh generation until a certain number of CPs are added.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Disabled mesh generation until a certain number of CPs are added. - by boriskourt - 05-02-2021, 09:39 AM
RE: Disabled mesh generation until a certain number of CPs are added. - by _Aka_ - 05-02-2021, 10:02 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Is there a way to generate UVs along deformed and copied mesh? | kubak | 1 | 304 |
03-18-2026, 08:34 PM Last Post: _Aka_ |
|
| Replace deform mesh on volume spots | Kokoriko49 | 1 | 2,316 |
06-09-2025, 06:49 PM Last Post: _Aka_ |
|
| Mesh Generation between two splines | vatan | 4 | 3,613 |
02-14-2025, 07:11 AM Last Post: vatan |
|
| Disable a spline's gizmo when not selected or disabled. | mikechr2000 | 1 | 1,764 |
02-03-2025, 09:34 AM Last Post: _Aka_ |
|