Allow higher amount of mesh-faces on extrusion

Thread Rating:

Linear Mode

Allow higher amount of mesh-faces on extrusion

King_of_Limbs Offline

Junior Member

Posts: 2
Threads: 1
Joined: Jul 2020

07-11-2020, 04:25 PM

I had Cache Density at 100 which does not work as I would think it should?:

It only starts having an effect when i massively turn up the Max Points per Unit. Then I get like 8 mesh faces:

Find

« Next Oldest | Next Newest »

Messages In This Thread

RE: Allow higher amount of mesh-faces on extrusion - by King_of_Limbs - 07-11-2020, 04:25 PM

Possibly Related Threads…
Thread		Author	Replies	Views	Last Post
	Is there a way to generate UVs along deformed and copied mesh?	kubak	1	299	03-18-2026, 08:34 PM Last Post: _Aka_
	Replace deform mesh on volume spots	Kokoriko49	1	2,313	06-09-2025, 06:49 PM Last Post: _Aka_
	Mesh Generation between two splines	vatan	4	3,597	02-14-2025, 07:11 AM Last Post: vatan
	Create Mesh Node, Make Static Options	rickgplus	1	1,822	01-23-2025, 10:12 AM Last Post: _Aka_