Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Allow higher amount of mesh-faces on extrusion
#2
Hi,
The problem is not there, but in the cache density of your spline. For very small splines, the default cache density is not high enough. Read this to see how to fix that:
https://curvyeditor.com/documentation/pe...che_points
Have a nice day
Available for freelance work, feel free to reach out: toolbuddy.net
Please consider leaving a review for Curvy, this helps immensely. Thank you.
Reply


Messages In This Thread
RE: Allow higher amount of mesh-faces on extrusion - by _Aka_ - 07-11-2020, 03:14 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Is there a way to generate UVs along deformed and copied mesh? kubak 1 299 03-18-2026, 08:34 PM
Last Post: _Aka_
  Replace deform mesh on volume spots Kokoriko49 1 2,313 06-09-2025, 06:49 PM
Last Post: _Aka_
  Mesh Generation between two splines vatan 4 3,598 02-14-2025, 07:11 AM
Last Post: vatan
  Create Mesh Node, Make Static Options rickgplus 1 1,822 01-23-2025, 10:12 AM
Last Post: _Aka_

Forum Jump: