04-08-2019, 12:38 PM
Hi,
To get the length of the segment between CP0000 and CP0001, you cal call CP000.Length. The Length is computed using linear approximations of the curve, so the less cache density your spline will have, the less precise Length will be.
So based on this, your movement speed should be CP000.Length / 5.2
Did this answer your question?
To get the length of the segment between CP0000 and CP0001, you cal call CP000.Length. The Length is computed using linear approximations of the curve, so the less cache density your spline will have, the less precise Length will be.
So based on this, your movement speed should be CP000.Length / 5.2
Did this answer your question?
Available for freelance work, feel free to reach out: toolbuddy.net
Please consider leaving a review for Curvy, this helps immensely. Thank you.
Please consider leaving a review for Curvy, this helps immensely. Thank you.