Toolbuddy Support Forum › Unity Asset Support Forums › Curvy Splines v
Shape extrusion "range" changes in run time to "length"

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Shape extrusion "range" changes in run time to "length"
hawken Offline
Junior Member
**
Posts: 44
Threads: 14
Joined: Dec 2017
#1
Bug  12-19-2017, 10:52 AM (This post was last modified: 12-21-2017, 09:36 AM by hawken.)
when I set up an extrusion range, sometimes in run time it will change from "range" to "length", using the end float number.

This only seems to happen when I close the spline, open splines are fine  Huh

[Image: Screen%20Shot%202017-12-19%20at%2019.44.28.png]

to this

[Image: Screen%20Shot%202017-12-19%20at%2019.46.31.png]

this makes the extrusion 0.75 of the track length instead of 0.25
Find
Reply


Messages In This Thread
Shape extrusion "range" changes in run time to "length" - by hawken - 12-19-2017, 10:52 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Absolute offset for shape extrudes rickgplus 1 1,630 03-21-2025, 12:37 PM
Last Post: _Aka_
  How to get length starting from one spline to connected nth spline Dragon-3623 1 1,615 05-14-2024, 04:52 PM
Last Post: _Aka_
  Rasterized Path Range issue proton 7 4,813 04-30-2024, 11:17 AM
Last Post: _Aka_
  Incorrect mesh alignment after extrusion on curved path Thinkurvy 10 5,878 04-17-2024, 10:57 AM
Last Post: _Aka_

Forum Jump: