Curvy Splines Support Forum › Curvy Splines › Curvy Splines - support forum v
How make a new connection between splines ?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
How make a new connection between splines ?
adeel_hamza Offline
Junior Member
**
Posts: 3
Threads: 1
Joined: Nov 2019
#1
11-13-2019, 05:59 AM
i am new here can you please tell me how we make a new connection between two splines. i try to make connection but i not understand how give second point to connection  Sad kindly help me


Attached Files Image(s)
   
Find
Reply
adeel_hamza Offline
Junior Member
**
Posts: 3
Threads: 1
Joined: Nov 2019
#2
11-13-2019, 06:36 AM
After hour of searching finally find this solution kindly make a video on connection also for new user its difficult


Select 2 or more control points of a spline and press [Connect] on the left hand Toolbar.
[Connect] does only appear if it's valid to connect any points.
Find
Reply
_Aka_ Offline
Administrator
*******
Posts: 1,076
Threads: 53
Joined: Jun 2017
#3
11-13-2019, 11:09 PM
Hi,
You seem to use an old version of Curvy. The Connection inspector was reworked to be easier to understand in Curvy 5.1.0.
A lot of things were fixed since the version you are using, I advise you to upgrade to the latest version.
Have a nice day
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Find
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Spline deformation & Bezier spline connection alignment digot 7 47 11 hours ago
Last Post: _Aka_
  Make hard angle cll3m 3 140 03-22-2021, 05:27 PM
Last Post: _Aka_
  Combine splines of different interpolation for use in generator leeharris 3 214 02-28-2021, 07:27 AM
Last Post: _Aka_
  Frequent runtime updates of Curvy Generator for simulating plant growth using Splines h4ck3rd4wg 6 1,087 10-02-2020, 07:57 PM
Last Post: _Aka_

Forum Jump: