Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
I added connection to my cp. but i can not add follow-up
#1
Hello. I need helps.

I added connection to my control point. then i tried add follow-up.
but there is no follow-up on the list.

maybe i did not check all of conditions. but i do not know what it is.
so if you know please tell me.

thanks to read :0
Have a good day.


Attached Files Image(s)
   
Reply
#2
Hi,
The follow up is a Control Point that is also part of the connection. Since your connection has no other CP other than SplineB.CP000, there is no candidates to select follow up from.
In short, add another CP to the connection.
Thanks, and have a good day too
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Reply
#3
how add another CP to connection ?
Reply
#4
For future reference, answer is here: https://forum.curvyeditor.com/thread-758...ml#pid2855
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Disabled mesh generation until a certain number of CPs are added. boriskourt 1 219 05-02-2021, 10:02 AM
Last Post: _Aka_
  Spline deformation & Bezier spline connection alignment digot 7 777 04-18-2021, 03:39 PM
Last Post: _Aka_
  To dynamic generate the connection between paths Canis 4 1,631 08-07-2020, 07:33 PM
Last Post: _Aka_
  Null reference when spline controller added runtime jh092 1 1,035 06-19-2020, 09:21 AM
Last Post: _Aka_

Forum Jump: