Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Connecting only last and first Control Point
#1
Hello,

I'd like to connect last and first CP (only them) so I can generate mesh at this section. If I set splines last CP (41st) as the Start CP, I cannot set CP0000 ast the End CP. Leaving End CP empty basicaly creates mesh between CP0000 and CP0041 without connecting last and first even though I have set Connected to true in the spline itself.

[Image: AKrjxCX.png]
Reply
#2
Hi,

If I understood your issue properly, what you need is to set your spline as Closed, as you can see in the image below
   
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
Photo How to check if a point is inside of a polygon? XtroTheArctic 1 1 03-20-2023, 08:53 AM
Last Post: _Aka_
Video How do I merge splines only if some control points are at the sam position? arcade.autumn 5 14 02-13-2023, 09:35 AM
Last Post: _Aka_
  Control handles gone for control points! :( danne_lindwall 3 5 02-10-2023, 08:49 AM
Last Post: _Aka_
  Find intersection point soccertrash 5 27 10-22-2022, 05:46 PM
Last Post: _Aka_

Forum Jump: