Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Rough edges on tight corners
#1
Apologies if this has already been covered somewhere, but I couldn't find anything.

When I do shape extrusion, is there any way to avoid the mesh from crossing over itself and creating rough edges? It especially happens on the inside wall when the angle is tight.

I've tried adjusting the Path's Angle Threshold but it didn't help.

Here is an example that shows the problem:

https://pasteboard.co/qFw6ylvXgCvj.png
[Image: qFw6ylvXgCvj.png]

Thanks!
Reply


Messages In This Thread
Rough edges on tight corners - by migwellian - 03-16-2023, 02:01 PM
RE: Rough edges on tight corners - by migwellian - 03-17-2023, 10:00 AM
RE: Rough edges on tight corners - by _Aka_ - 03-17-2023, 10:33 AM
RE: Rough edges on tight corners - by migwellian - 03-17-2023, 12:16 PM
RE: Rough edges on tight corners - by _Aka_ - 03-18-2023, 05:47 PM
RE: Rough edges on tight corners - by migwellian - 03-20-2023, 09:48 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Ball jumps on colliders edges Dmitrii_Dzh 8 25 04-26-2022, 02:17 PM
Last Post: _Aka_
  Mesh Lines - Horizontal and Vertical Edges Krypton 14 4,759 09-23-2020, 02:16 AM
Last Post: Krypton
  How to spawn GameObjects on corners of the liinear spline? Pixel Flipper 7 5,083 09-18-2019, 07:03 PM
Last Post: _Aka_
  Mesh Generator, Hard / Faceted Edges? nomadigi 2 4,674 01-31-2018, 04:54 PM
Last Post: nomadigi

Forum Jump: