Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Activate Curvy Generator After Scene Load
#2
Hi
I was never confronted to you use case, so if you can send me a simplified reproduction case, that would help me investigate the issue.
Until then, the only things that I can say are probably not that helpful:
  • Check the CurvyGenerator.IsInitialized property
  • Check the CurvySpline.IsInitialized property
  • Manually call the CurvyGenerator and CurvySpline Refresh method
  • Make sure the CurvyGenerator's AutoRefresh and RefreshDelay have valid values.
  • Try to wait for a couple of frames after the scene switching before doing the things above.
I hope this helped
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Reply


Messages In This Thread
RE: Activate Curvy Generator After Scene Load - by _Aka_ - 04-30-2021, 08:18 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  snap to the curve created by the curvy splines segment points ShiroeYamamoto 0 0 4 hours ago
Last Post: ShiroeYamamoto
Exclamation Extending Curvy Generator for Advanced Lofting - Feasibility Check amutp 2 4 Yesterday, 07:25 AM
Last Post: amutp
  8.8.0 is live, and it improves Curvy Generator greatly _Aka_ 0 6 Yesterday, 03:23 AM
Last Post: _Aka_
  Generating GO only on CPs in Generator GameDeveloperek4123 1 6 03-04-2024, 11:06 AM
Last Post: _Aka_

Forum Jump: